Thanks I have now done the same till this bug is fixed. This lets each gpu run it's own project with it's own priority settings. Put together that would mean gpu 0 can run Poem but Poem but cannot run Collatz, and vice versa for gpu 1. You put that just before or after the other gpu exclude lines. To exclude your 2nd gpu from say Collatz you would add more lines:
Those lines tell Boinc to exclude gpu 1 from the project poem, when Boinc first starts up in the event log tells you which gpu is 0 and which gpu is 1. You can use a line in your cc_config.xml file to do that: If I were to try again I was going to run another client and ignore the 1070 on one, and the 970 on the other to try and get separate tasks on each card. One card should be faster than the other. I tried the ngpus = 1 as well but the times did not line up. Since They were not matched, a 1070 and 970, I didn't think they were being utilized the best. I had the same thing with NV GPUs like last week and just went to another project. Init_data.xml file for device 1 Moo! task - shows BOINC has assigned the task to the correct GPU device. Init_data.xml file for device 0 Moo! tasks - shows BOINC has assigned the task to the correct GPU device. Taks manager - attempt to find dnetc wrapper commandline From their posts I understand that there was an API change at that point that might have been missed.īOINC shows tasks, one for each device 0 and device 1 - GPU-Z shows 0% Load on GPU device 0īOINC App_config file (this makes no difference) The admins helped me to investigate and in the end their verdict was that this was a problem with the Moo wrapper and not with BOINC as BOINC was assigning the task to the correct GPU device and it appears as if the Moo wrapper was ignoring the BOINC instruction. Make sure overdrive and crossfire is off - did that. I took them one by one and did a test - all good.ĥ. Plugged monitors into both cards - I did that.Ĥ. Checked, mother board support PCIe x 16 2.0.to allow 2 cards to run at the same time - I confirmed mine does.ģ. Enable all GPUS in the BOINC config file.Ģ. I have tried the following before posting.ġ. The one card runs 100% load while the other does nothing. I used GPU-Z to investigate the GPUs when i noticed the one was running very hot compared to the other and that is when I discovered that only of the cards had any load. When using Moo wrapper, BOINC assigns 2 tasks, 1 for each GPU. I have 2 legacy ATI Radeon HD 3870 cards. Mikey has tried to assist me via private messages so far. I found the following problem 3 weeks ago when I swapped to Moo! wrapper but because I process as part of the GRCPool with gridcoin I could not post here as my user had no credit, last night I swapped one of the machines back to boincstat to get credit to post here.
#Boinc config file windows 7
Hi I am running windows 7 64bit with BOINC 7.8.3 (圆4) (was 7.8.2 at the time the images were taken)
0 kommentar(er)
